Annunciator - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

Annunciator

OUT F
RnPCPU
RnCPU RnENCPU
(Process)
This instruction outputs the operation result up to the OUT F instruction to the specified annunciator.
Ladder
(d)
FBD/LD
EN ENO
d
( is to be replaced by OUT.)
■Execution condition
Instruction
OUT F
Setting data
■Description, range, data type
Operand Description
(d) Target annunciator number
EN Execution condition
ENO Execution result
*1 Only labels assigned to the annunciator can be used.
■Applicable devices
Operand Bit
X, Y, M, L,
SM, F, B, SB,
FX, FY
*1

(d)
*1 Only F can be used.
Processing details
• This instruction outputs the operation result up to the OUT F instruction to the specified annunciator.
• When the annunciator (F) is turned on by this instruction, the following are performed.
• The USER LED of the CPU module turns on.
• The annunciator number (F number) to be turned on is stored in the special register (SD64 to SD79).
• The value in SD63 is incremented by one.
• If the value in SD63 is 16 (meaning 16 annunciators are already on), the annunciator number will not be stored in the
special register (SD64 to SD79) even when a new annunciator turns on.
• When the annunciator (F) is turned off by this instruction, the following are performed.
• The coil turns off, but the USER LED status and the data in SD63 to SD79 remain unchanged.
• To turn off the USER LED or delete the annunciator number that has been turned off by this instruction from SD63 to SD79, use the RST F instruction.
Operation error
There is no operation error.
5 SEQUENCE INSTRUCTIONS
188
5.3 Output Instructions
RnPCPU RnSFCPU RnSFCPU
(Redundant) (Standard) (Safety)
Execution condition
Every scan
Word
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
 
ST
ENO:=OUT(EN,d);
Range



Double word
U\G, J\, Z LT, LST,
U3E\(H)G LC
  
Data type Data type (label)
Bit ANY_BOOL
Bit BOOL
Bit BOOL
Indirect Constant
specification
LZ K, H
  
*1
Others
E $
  