CHAPTER 2
This chapter describes the system configuration of the CT input module.
2.1
Applicable Systems
This section describes applicable systems.
(1) Applicable CPU modules and base units, and number of mountable modules
(a) When mounted with a CPU module
For the CPU modules, the number of modules, and base units applicable to the Q68CT, refer to the user's
manual for the CPU module used.
Note the following when the Q68CT is mounted with a CPU module.
• Depending on the combination with other modules or the number of mounted modules, power supply
capacity may be insufficient. Pay attention to the power supply capacity before mounting modules, and if
the power supply capacity is insufficient, change the combination of the modules.
• Mount a module within the number of I/O points for the CPU module. If the number of slots is within the
available range, the module can be mounted on any slot.
Remark
To use a C Controller module with the CT input module, refer to the C Controller Module User's Manual.
(b) When mounted on MELSECNET/H remote I/O station
For the MELSECNET/H remote I/O station, the number of modules, and base units applicable to the Q68CT,
refer to the Q Corresponding MELSECNET/H Network System Reference Manual (Remote I/O network).
18
SYSTEM CONFIGURATION