Mitsubishi Electric MELSEC-Q series User Manual page 190

(From the previous page)
188


3.
Click the
Monitor" window.
4.
Open the "Device/Buffer Memory Batch Monitor"
window.
[Online] [Monitor]
Batch]
5.
Monitor Conversion enable/disable setting (Un\G0)
to check if the channel to be used is set to Enable
(0).
6.
Monitor CH Digital output value (Un\G11 to
Un\G18) to check if the digital conversion is
performed properly.
7.
Before starting the control, check the CT input
module for the following. If an error occurs, refer to
TROUBLESHOOTING (
and take a corrective action.
• If the RUN LED is on.
• If the ERR. LED is off.
• If Error flag (XF) is off.
button to close the "System
[Device/Buffer Memory
Page 221, CHAPTER 11)