Mitsubishi Electric MELSEC-Q series User Manual page 110

(7) Averaging process setting (Un\G24, Un\G25)
Set these areas when selecting sampling or averaging processing for each channel.
Averaging processing includes time average, count average, moving average, and primary delay filter.
For details on the digital conversion method, refer to the following.
• Digital Conversion Method (
Averaging process setting
(CH1 to CH4) (Un\G24)
Averaging process setting
(CH5 to CH8) (Un\G25)
• When the value out of the setting range above is written in a channel, an error occurs in the channel. The
error code (33) is stored in Latest error code (Un\G19), and Error flag (XF) turns on. The conversion
processing is performed based on the setting before the error occurs.
(a) Enabling the setting
Turn on then off Operating condition setting request (Y9) to enable the setting.
(b) Default value
All channels are set to Sampling processing (0
(8) Sampling cycle setting (Un\G26)
Set the sampling cycle shared by all the channels.
For details on the sampling cycle switching function, refer to the following.
• Sampling Cycle Switching Function (
• When the value out of the setting range above is written in a channel, an error occurs in the channel. The
error code (350) is stored in Latest error code (Un\G19), and Error flag (XF) turns on. The sampling cycle
performs in the setting before the error occurs.
(a) Enabling the setting
Turn on then off Operating condition setting request (Y9) to enable the setting.
(b) Default value
10ms/8CH (0) is set as the default value.
108
Page 36, Section 4.5)
b15 to
CH4
CH8
Digital conversion method
Sampling processing
Time average
Count average
Moving average
Primary delay filter
Sampling cycle
10ms/8CH
20ms/8CH
50ms/8CH
100ms/8CH
b12 b11 to b8 b7
CH3
CH7
).
H
Page 35, Section 4.4)
to b4 b3 to b0
CH2 CH1
CH6 CH5
Setting value
0
H
1
H
2
H
3
H
4
H
Setting value
0
H
1
H
2
H
3
H