Mitsubishi Electric MELSEC-Q series User Manual page 165

CHAPTER 9 PROGRAMMING
9
(2) Program example
Turn on Module READY check flag.
Set CH1 Input range setting.
Set CH2 Input range setting.
Set CH3 Input range setting.
Enable CH1 to CH3 Digital
conversion.
CH2 Average time/Average number
of times/Moving average/Time
constant settings
CH3 Average time/Average number
of times/Moving average/Time
constant settings
Set CH1 to CH3 averaging
process setting.
Set conversion speed.
Activate CH1 Input signal error
detection.
Set CH2 and CH3 Warning output.
Set CH2 Process alarm lower lower
limit value.
Set CH2 Process alarm lower upper
limit value.
Set CH2 Process alarm upper lower
limit value.
Set CH2 Process alarm upper upper
limit value.
Set CH3 Rate alarm warning
detection period.
Set CH3 Rate alarm upper limit
value.
Set CH3 Rate alarm lower limit
value.
Set CH1 Peak current detection
setting.
Set CH1 Peak current detection
time.
Set CH1 Peak current detection
value.
Turn on Operating condition setting
request.
Turn off Module READY check flag.
Turn off Operating condition setting
request.
163