Suzuki Grand Vitara XL-7 Service Manual page 512

5) Install brake applying tube (1) so that its lug fits in a in transmis-
sion case. After installation, check that 4 lugs (3) along the un-
derside of brake applying tube fit inside of reverse brake piston
and leaf spring (2) is installed properly.
6) Remove reverse brake reaction plate of planetary gear assem-
bly and align lugs of reverse brake plate, reverse brake disc and
reverse brake packing plate. Install planetary gear assembly to
transmission case so that aligned lugs fit in groove in transmis-
sion case.
7) Measure clearance between reverse brake plate and lugs of
transmission case.
If measured value is less than standard range, it is possible that
something is installed improperly or dust or fluid is on reverse
brake disc, etc. If it exceeds standard range, adjust it to standard
clearance with selective reverse brake backing plates shown
below.
Standard clearance between reverse brake plate and lugs
of transmission case:
0.52 – 1.27 mm (0.02 – 0.05 in.)
Available plate
thickness
8) Install reverse brake reaction plate so that its lug with dent
comes to the same position as leaf spring.
1. Relief spring
AUTOMATIC TRANSMISSION (4 A / T) 7B1-107
3.25, 3.5, 3.75, 4.0, 4.25, 7.66 mm
(0.128, 0.138, 0.148, 0.157, 0.167,
0.302 in.)