Suzuki Grand Vitara XL-7 Service Manual page 238

6A3-40 ENGINE MECHANICAL (RHZ ENGINE)
3) Install knock pins (1) to cylinder block.
4) Install new cylinder head gasket (2) to cylinder block.
A: Crankshaft pulley side
B: Flywheel side
5) Check to make sure that length of cylinder head bolt as shown
6) Apply engine oil to cylinder head bolts and tighten them gradual-
A: Camshaft pulley side
7) For installation, reverse removal procedure noting the following.
Thickness identification notch(es) (3) provided on gasket should
come to oil filter side.
in figure does not exceed specified value.
"a": Less than 133.4 mm (5.25 in.)
ly as follows.
a) Tighten all bolts to 20 N
numerical order in figure.
b) In the same manner as in Step a), tighten them to 60 N
(6.0 kg-m, 43.5 lb-ft).
c) Retighten all bolts 220_ according to numerical order in fig-
ure.
D Install turbocharger bracket bolt (1). Tighten bolt to specified
torque.
Tightening Torque
Turbocharger bracket bolt (a): 30 N
D Using new gaskets, connect oil return pipe (2) and lubrication
pipe (3) to turbocharger. Tighten bolt to specified torque.
Tightening Torque
Lubrication pipe union bolt (b): 20 N
ft)
.
m (2.0 kg-m, 14.5 lb-ft) according to
.
m (3.0 kg-m, 22.0 lb-ft)
.
m (2.0 kg-m, 14.5 lb-
.
m