Suzuki Grand Vitara XL-7 Service Manual page 249

REMOVAL
1) Remove engine assembly from body as previously outlined.
2) Remove following parts from engine as previously outlined.
D Oil pan and oil pump strainer
D Intake manifold and exhaust manifold
D Cylinder head cover
D Timing belt cover
D Timing belt, belt tensioner, roller and crankshaft timing belt
pulley
D Oil pump, oil pump drive sprocket and gasket holder plate
D Cylinder head assembly
D Piston and connecting rod
3) Remove clutch cover, clutch disc and flywheel (drive plate and
CKP (Engine speed) sensor ring for A/T).
Special Tool
(A): 09924-17811
4) Loosen crankshaft bearing cap bolts in such order as indicated
in figure a little at a time and remove bearing caps.
5) Remove thrust bearings (lower side) (1) and rear oil seal (2).
6) Remove crankshaft from cylinder block.
7) Remove thrust bearings (upper side).
ENGINE MECHANICAL (RHZ ENGINE) 6A3-51