Suzuki Grand Vitara XL-7 Service Manual page 234

6A3-36 ENGINE MECHANICAL (RHZ ENGINE)
A: Camshaft timing belt pulley side
INSTALLATION
1) Install valve rocker (1) with ball valve rocker (2) to cylinder head.
Apply engine oil around valve rocker and ball valve rocker and
then install them to cylinder head.
2) Apply sealant to mating surfaces of camshaft housing.
"A" Sealant: 99000-31140
3) Apply engine oil to cams and journals on camshaft (1) and set
camshaft to camshaft housing (2). Fit camshaft housing with
camshaft to cylinder head.
4) After applying oil to housing bolts, tighten them temporarily first.
Then tighten them by following sequence as indicated in figure.
Tighten a little at a time and evenly among bolts and repeat tight-
ening sequence two or three times before they are tightened to
specified torque.
Tightening Torque
.
10 N m (1.0 kg-m, 7.5 lb-ft)
5) After applying grease to oil seal lip, fit camshaft oil seal (1) by us-
ing special tool.
Special Tool
(A): 09913-56510/OUT0000152