Suzuki Grand Vitara XL-7 Service Manual page 396

7A2-48 MANUAL TRANSMISSION
A. Chamfered side
B. 5th & reverse synchronizer hub side
e) Turn 5th gear synchronizer pull ring (1) around 45 degrees
as shown in the figure.
f) Make sure that position of 5th gear synchronizer pull ring
protrusion (1) is in the same position as the figure shows. It
isn't, turn 5th gear synchronizer pull ring again, setting the
same position as figure shows.
15) Attach 5th gear synchronizer ring assembly (3) to 5th & reverse
synchronizer sleeve (4) so that spline teeth of 5th gear syn-
chronizer ring assembly (1), which was assembled in step "a"
through "f" ,and key location teeth of 5th reverse synchronizer
sleeve (2) mesh.
16) Install 5th & reverse synchronizer sleeve assembly (1), which
was assembled in step 15), to 5th reverse synchronizer hub
(2).
17) Install counter shaft 5th gear to counter shaft ,fitting protrusion
of 5th gear synchronizer cone ring (1) into hole of counter shaft
5th gear (2) as shown in the figure.