Assembling Unit - Suzuki Grand Vitara XL-7 Service Manual

7F-18 DIFFERENTIAL (REAR)

ASSEMBLING UNIT

1) Place bearing outer races on their respective bearings.
Used left and right outer races are not interchangeable.
2) Install case assembly in carrier.
3) Install side bearing adjusters on their respective carrier, making
sure adjuster are threaded properly.
4) Align match marks (1) on cap and carrier. Screw in 2 side bear-
ing cap bolts 2 or 3 turns and press down bearing cap by hand.
NOTE:
If bearing cap does not fit tightly on carrier, side bearing ad-
juster is not threaded properly. Reinstall adjuster.
5) Tighten cap bolts (provisional torque).
Tightening torque
Bearing cap bolt (Provisional torque) (a):
15 N
6) Tighten both bearing adjusters (2) so as to obtain specified gear
backlash and at the same time, obtain preload of side bearing.
NOTE:
D Be sure to apply measuring tip of dial gauge at right
angles to convex side of tooth.
D As a practical measure the following would be recom-
mended to obtain specified backlash and side bearing
preload at the same time.
– Obtain specified backlash by turning both adjusters in-
– Tighten both adjusters further by one notch at a time.
D Measure at least 4 points on drive bevel gear periphery.
Standard backlash:
0.13 – 0.18 mm (0.005 – 0.007 in.)
Special tool
(A): 09930-40120
(B): 09930-40113
(C): 09900-20701
1. Bearing cap bolt
.
m (1.5 kg-m, 11.0 lb-ft)
ward lightly.