NEC NEAX 2400 ICS Features Manual page 85

Service Conditions (cont'd)
14. The following issues of firmware equipped on the circuit cards are required for the D
III with 2-line LCD.
Circuit Card
SPA-16ELCH-E
SPA-16ELCH-F
SPA-DAIA-DD (2M AMI)
SPA-2DAIA-DD (2M AMI)
SPA-DAIC-DD (1.5M AMI)
Note: Hardware SPA-8COTBJ is required for this feature.
15. In case of using D
there are conditions as follows (same as current conditions). If the D
with applicable D
a.) Multi line will not display the Caller ID.
b.) The display of the lower LCD (e.g. MW indication) is erased when on-hook and this will
not be displayed until the station is on hook.
16. Display conditions are shown below. Also, the ID display is ISDN service has the same
conditions.
a.) It is assigned by system data in which display of the calling number or name has priority
on termination.
When the calling name display has priority, the 2-line LCD displays:
The one-line LCD displays:
term
The D
When the calling number display has priority, the 2-line LCD displays:
The one-line LCD displays:
term
The D
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Analog Caller ID (Class SM)
SP-3124 16ELCD PROG-D
SP-3125 16ELCD PROG-TD
SP-3126 2WDLI PROG-D
SP-3126 2WDLI PROG-D
SP-3126 2WDLI PROG-D
term
s with interface cards other than the above (including the D
term
s, the conditions are same.
Calling name (16 digits)
Series E displays:
Calling name (24 digits)
Calling number (16 digits)
Series E displays:
Calling name (24 digits)
Firmware
Calling number (8 digits) *1
Calling number (8 digits) *2
Calling number (8 digits) *1
Calling name (8 digits)
Calling number (8 digits) *2
Calling number (8 digits) *1
term
Issue
5 or later
5 or later
6 or later
6 or later
6 or later
term
Series III),
term
s are used in conjunction
*2
*2
*1
*2
*2
Page 55
A-125
series