Slumber Time - Do Not Disturb - NEC NEAX 2400 ICS Features Manual

S-106
S-106
General Description
This service allows a slumber time for up to four times per day on a Station group basis. During the
slumber time, all stations in the group concerned are placed into "Do Not Disturb" mode, and incoming
calls (Station/DID/DIT) will be routed to the Attendant or an announcement machine.
Operating Procedure
No manual operation is required.
Service Conditions
1. The stations for which this feature is set are determined by the station number of the group
preassigned by the MAINTENANCE ADMINISTRATION TERMINAL (MAT) and Slumber Time
data; not by the Service Restriction Class.
2. This feature cannot be set for data terminals.
3. This feature cannot be set for Night stations. (NIGHT CONNECTION [N-1] [N-2] take
precedence over SLUMBER TIME - DO NOT DISTURB.)
4. There can be up to seven Slumber Time Groups per system. There is no limitation to the number
of stations that can be assigned to one group.
5. A maximum of four Slumber Time assignments can be made for one Slumber Time Group. When
setting more than one assignment, assure that the Times do not overlap each other. Also, a
transfer destination can be assigned on each Slumber Time Data basis.
6. A station cannot be assigned to more than one Slumber Time Group.
7. A Night Transfer Station cannot be assigned to a Slumber Time Group.
8. During Slumber Time, incoming calls (station/DID/DIT) are routed to an Attendant Console or
announcement machine. When an Attendant Console is designated as the transfer destination,
the transfer call is terminated to the ICPT key on the Attendant Console. When an
announcement machine is designated as the transfer destination but is not assigned in data by
AAED command, the caller receives a Busy Tone (BT).
9. An announcement machine with one channel can be connected to each station group. When
connecting several station groups to an announcement machine, all groups must be assigned to
the same single route and trunk.
10. A station in Slumber Time mode can place an outgoing call.
11. Call transfer to a station in Slumber time mode after holding the call by CONSULTATION HOLD
[C-17] is possible only when an Attendant Console is designated as the transfer destination. (The
call is transferred to the Attendant Console.) If the announcement machine is designated as the
transfer destination, the transfer call is routed to Reorder Tone (ROT) connection.
12. The caller is not always connected to the announcement from its beginning.
13. Call origination is available during Slumber Time.
14. Station group or time is changed, assigned, or cancelled by MAT command.
15. There is no external indication showing Slumber Time set.
Page 498

Slumber Time - Do Not Disturb

Slumber Time - Do Not Disturb
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4