Configuration; Enabling Batch Security; Configuring Batch Access Privileges; E.3 Configuration - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

E.3 Configuration

E.3.1 Enabling batch security
Note. Batch security can be enabled only if the Security system parameter is set to Advanced – see
Section 7.7.5, page 74. If the Security system parameter is set to Basic, batch security is automatically
disabled and cannot be enabled.
To enable batch security, access Common Configuration (see Section 7.7.5, page 74) and select the
Security tab.
Security
Security type
Security system
E.3.2 Configuring batch access privileges
To enable operators to manually control batches, access Common Configuration (see Section 7.7.6,
page 76) and select the User' tab.
User
User 1 Name
User 1 Access
OI/RVG200-EN
Set the Security type.
Set to Advanced to enable batch security.
Configure User 1 (System Administrator)
Ensure Batch is ticked to enable User 1 to start and stop batches – see
Section E.2, page 174.
Repeat as required for other users.
Refer to page 178 to set the required type of batch recording security.
Appendix E – Batch recording
177