Channel Configuration; Recording Channel Setup - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

7.9 Channel configuration

Fig. 7.10 Recording channel configuration

7.9.1 Recording channel setup

Setup
Source ID *
Trace color / Zone
* If this parameter is changed from any previous setting other than None, a new internal data file for this
recording channel is created. All historical data stored internally for this channel is lost. If this parameter is
changed from a previous setting of None, new internal data files for all enabled recording channels are
created. Any unarchived data is lost.
86
Select the signal source for the selected channel. This can be any external
analog or digital signal – see Appendix A, page 146 for full list.
Note.

The tabs change according to the selection made.

Setting a channel source to None does not switch off the analog
input to which the channel was assigned previously (the analog
input continues to be monitored). To switch off an analog input, set
for the required channel to Off – see Section 7.9.2, page 90.
Type
Select the color used to display the trace and its tag on Chart- and
Indicator-views – 24 colors are available.
Each recording channel can be configured to position its trace in one of 9
specific zones in the Chart views in order to separate traces that would
otherwise be very close to each other.
Select one of the pre-defined zones available if required.
7 Configuration
OI/RVG200-EN