Ethernet Module - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

7.10.4 Ethernet module

The Ethernet module fitted to the recorder contains an embedded web server enabling the recorder's data
and status to be viewed remotely using an internet browser on a PC. The web server supports up to 8
independent connections.
Ethernet
DHCP
IP-address
Note. The following parameters are displayed only if DHCP is set to Disabled.
Subnet mask
Default Gateway
OI/RVG200-EN
Set to Enabled to enable the recorder to obtain a valid IP address
automatically from a server on the network.
Set to Disabled to enable the IP address to be configured manually.
If DHCP is set to Enabled, the IP-address is assigned automatically and
cannot be changed.
If DHCP is set to Disabled, enter the IP-address assigned to the recorder.
The IP address is used by the TCP / IP protocol to distinguish between
different devices. The address is a 32 bit value expressed with four values
(0 to 255), each separated by a period (.).
The subnet mask is used to indicate which part of the IP address is for the
network ID and which is for the host ID. Set as 1s each bit that is part of
the network ID (for example, 255.255.255.0 indicates that the first 24 bits
are for the network ID).
Set the IP address for the default gateway (for example, router or switch)
required to communicate with other networks. This setting may not be
required. The default setting is 0.0.0.0.
7 Configuration
117