Fastener Caution; Suspension Caution; Wheels And Tires Caution; Abs Caution - Suzuki SX4 Service Manual

00-11 Precautions:

Fastener Caution

CAUTION
!
When fasteners are removed, always reinstall
them at the same location from which they
were removed. If a fastener needs to be
replaced, use the correct part number
fastener for that application. If the correct
part number fastener is not available, a
fastener of equal size and strength (or
stronger) may be used. Fasteners that are not
reused, and those requiring thread-locking
compound, will be called out. The correct
torque value must be used when installing
fasteners that require it. If the conditions are
not followed, parts or system damage could
result.

Suspension Caution

CAUTION
!
• All suspension fasteners are an important
attaching part in that it could affect the
performance of vital parts and systems,
and/or could result in major repair
expense. They must be replaced with one
of the same part number or with an
equivalent part if replacement becomes
necessary. Do not use a replacement part
of lesser quality or substitute design.
Torque values must be used as specified
during reassembly to assure proper
retention of this part.
• Never attempt to heat, quench or
straighten any suspension part. Replace it
with a new part or damage to the part may
result.

Wheels and Tires Caution

CAUTION
!
All wheel fasteners are important attaching
parts in that they could affect the
performance of vital parts and systems, and/
or could result in major repair expense. They
must be replaced with one of the same part
number or with an equivalent part if
replacement becomes necessary. Do not use
a replacement part of lesser quality or
substitute design. Torque values must be
used as specified during reassembly to
assure proper retention of all parts.
There is to be no welding as it may result in
extensive damage and weakening of the
metal.

ABS Caution

S7RW0A0000011
• When ABS control module is removed / installed, do
not use impact wrenches which generate shock or
impact to avoid damaging sensors in ABS control
module.
Precaution for Vehicle Equipped with ESP®
System
• When testing with any of the following equipments
(when vehicle is tested by rotating wheels (tires)
under vehicle stop), be sure to deactivate ESP®
system referring to "Precautions in Speedometer Test
or Other Tests in Section 4F" to obtain correct data.
– 2 or 4-wheel chassis dynamometer
– Speedometer tester
– Brake tester
– Etc.
S7RW0A0000012
ESP® control module
• When ESP® control module is removed / installed, do
not use impact wrenches which generate shock or
impact to avoid damaging sensors in ESP® control
module.
• When any of the following operation is done, calibrate
steering angle sensor referring to "Sensor Calibration
in Section 4F".
– When battery or dome fuse is removed.
– When steering angle sensor is replaced.
– When ESP® hydraulic unit is replaced.

Brake Caution

CAUTION
!
All brake fasteners are important attaching
parts in that they could affect the
performance of vital parts and systems, and/
or could result in major repair expense. They
S7RW0A0000013
must be replaced with one of same part
number or with an equivalent part if
replacement becomes necessary. Do not use
a replacement part of lesser quality or
substitute design. Torque values must be
used as specified during reassembly to
assure proper retention of all parts. There is
to be no welding as it may result in extensive
damage and weakening of the metal.
S7RW0A0000015
S7RW0A0000016
S7RW0A0000014