Diagnostic Information And Procedures; A/T System Check; Visual Inspection - Suzuki SX4 Service Manual

6. Output shaft speed sensor (VSS)

A/T System Check

Refer to the following items for the details of each step.
Step
1 Customer complaint analysis
1) Perform customer complaint analysis.
Was customer complaint analysis performed?
2 DTC / freeze frame data check, record and clearance
1) Check for DTC.
Is there any DTC(s)?
3

Visual inspection

1) Perform visual inspection.
Is there any faulty condition?
4 Visual inspection
1) Perform visual inspection.
Is there any faulty condition?
5 Trouble symptom confirmation
1) Confirm trouble symptom.
Is trouble symptom identified?
6 Rechecking and record of DTC / freeze frame data
1) Recheck for DTC referring to "DTC Check".
Is there any DTC(s)?
7 Rechecking and record of DTC / freeze frame data
1) Recheck for DTC referring to "DTC Check".
Is there any DTC(s)?
8 A/T basic check and A/T symptom diagnosis
1) Check and repair according to "A/T Basic Check" and "A/
T Symptom Diagnosis".
Are check and repair complete?
9 Troubleshooting for DTC
1) Check and repair according to applicable DTC flow.
Are check and repair complete?
10 Check for intermittent problems
1) Check for intermittent problems.
Is there any faulty condition?
11 Final confirmation test
1) Clear DTC if any.
2) Perform final confirmation test.
Is there any problem symptom, DTC or abnormal condition?
14. Transmission range sensor

Diagnostic Information and Procedures

Action
Automatic Transmission/Transaxle:
Yes
Go to Step 2.
Print DTC or write them
down and clear them by
referring to "DTC
Clearance". Go to Step
3.
Repair or replace
malfunction part. Go to
Step 11.
Repair or replace
malfunction part. Go to
Step 11.
Go to Step 6.
Go to Step 9.
Go to Step 9.
Go to Step 11.
Go to Step 11.
Repair or replace
malfunction part(s). Go
to Step 11.
Go to Step 6.
5A-17
S7RW0A5104001
No
Perform customer
complaint analysis.
Go to Step 4.
Go to Step 5.
Go to Step 8.
Go to Step 7.
Go to Step 8.
Go to Step 10.
Check and repair
malfunction part(s). Go
to Step 11.
Check and repair
malfunction part(s). Go
to Step 11.
Go to Step 11.
End.