Suzuki SX4 Service Manual page 528

3B-39 Differential:
4) Align holes of pinion shaft and differential case and
drive in differential pinion shaft pin till they are flush
with end surface of case.
Special tool
(A): 09922–85811
5) Put bevel gear (2) on differential case (3) and tighten
new bolts (1) to specified torque.
CAUTION
!
Use of any other bolts than that specified is
prohibited.
Tightening torque
Bevel gear bolt (a): 73 N·m (7.3 kgf-m, 52.0 lb-ft)
3
2
6) Press-fit differential right side bearing (1) with special
I5RW0A320042-01
7) Hold differential right side bearing (2) with special
1, (a)
I5RW0A320043-01
tools and hydraulic press.
Special tool
(A): 09913–80113
(B): 09926–48010
tool and press-fit differential left side bearing (1) with
special tools and hydraulic press.
NOTE
Be sure to use bearing holder for the purpose
of protecting lower bearing.
Special tool
(A): 09913–80113
(B): 09926–48010
(C): 09925–88210
I5RW0A320044-01
I5RW0A320045-01