Clutch Cover, Clutch Disc And Flywheel Inspection - Suzuki SX4 Service Manual

2) Using special tool, install input shaft bearing to
flywheel (1).
Special tool
(B): 09925–98210
3) Aligning clutch disc to flywheel center using special
tool, install clutch cover (1) and bolts (2). Then
tighten bolts (2) to specification.
NOTE
• While tightening clutch cover bolts,
compress clutch disc with special tool
(clutch center guide) by hand so that disc
is centered.
• Tighten cover bolts little by little evenly in
diagonal order.
Special tool
(A): 09924–17811
(B): 09923–36320
Tightening torque
Clutch cover bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-
ft)
4) Slightly apply grease to input shaft (1), then join
manual transaxle assembly with engine referring to
"Manual Transaxle Unit Dismounting and
Remounting in Section 5B".
"A": Grease 99000–25210 (SUZUKI Super
Grease I)
NOTE
When inserting transaxle input shaft to clutch
disc, turn crankshaft little by little to match
the splines.
I4RS0A530016-01
Clutch Cover, Clutch Disc and Flywheel
Inspection
Input Shaft Bearing
Check bearing (1) for smooth rotation and replace it if
abnormality is found.
I4RS0A530017-01
1
"A"
Clutch: 5C-8
I5RW0A530013-01
S7RW0A5306012
I3RM0A530014-01