Dtc P0106: Manifold Absolute Pressure Range / Performance - Suzuki SX4 Service Manual

DTC P0106: Manifold Absolute Pressure Range / Performance

Wiring Diagram
1
15 14 13 12 11
30 28 27 26
29
45 44 43 42 41
59
60 58 57 56
1. Manifold absolute pressure sensor
2. To A/C refrigerant pressure sensor (if equipped with A/C)
DTC Detecting Condition and Trouble Area
DTC detecting condition
• Difference between Max. manifold absolute pressure
value and Min. manifold pressure value is less than
specified value when engine running at idle speed.
• Difference between barometric pressure value and
manifold pressure value is less than specified value for 5
sec. at 2000 r/min. or more with acceleration pedal off
condition.
(2 driving cycle detection logic)
DTC Confirmation Procedure
NOTE
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation
Procedure".
• Intake air temperature at engine start: –10 °C (14 °F) to 80 °C (176 °F)
• Intake air temperature: –10 °C (14 °F) to 70 °C (158 °F)
• Engine coolant temperature: 70 °C (158 °F) or more
• Altitude (barometric pressure): 2500 m, 8200 ft or less (560 mmHg, 74.4 kPa or more)
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC using scan tool and warm up engine completely.
3) Run engine at idle speed for 1 min.
4) Check DTC and pending DTC.
2
GRY/RED
RED/BLK
GRY/BLU
3
E01
10 9 8 7 6 5 4 3
25 24 23 22 21 20 19 18
40 39 38 37 36 35 34 33
55 54 53 52 51 50 49 48
Engine General Information and Diagnosis:
GRY/RED C01-14
C01-53
GRY/BLU
C01-55
2 1 15 14 13 12 11
17 16 30 28 27 26
29
32 31 45 44 43 42 41
59
47 46 60 58 57 56
3. To other sensors
4. ECM
• Manifold absolute pressure sensor
• Manifold absolute pressure sensor vacuum passage
• Air intake system
• ECM
4
5V
5V
C01-58 BLK/ORN
C01-15
BLK
C01-30 BLK
E01-31 BLK
C01
10 9 8 7 6 5 4 3
25 24 23 22 21 20 19 18
40 39 38 37 36 35 34 33
55 54 53 52 51 50 49 48
Trouble area
1A-69
S7RW0A1104022
2 1
17 16
32 31
47 46
I6RW0D110023-01