Front Wheel Speed Sensor On-Vehicle Inspection; Front Wheel Speed Sensor Removal And Installation; Front Wheel Speed Sensor Inspection; Rear Wheel Speed Sensor On-Vehicle Inspection - Suzuki SX4 Service Manual

Front Wheel Speed Sensor On-Vehicle
Inspection
Refer to "Front and Rear Wheel Speed Sensor On-
Vehicle Inspection in Section 4E".
Front Wheel Speed Sensor Removal and
Installation
Refer to "Front Wheel Speed Sensor Removal and
Installation in Section 4E".

Front Wheel Speed Sensor Inspection

Refer to "Front and Rear Wheel Speed Sensor
Inspection in Section 4E".
Rear Wheel Speed Sensor On-Vehicle
Inspection
Refer to "Front and Rear Wheel Speed Sensor On-
Vehicle Inspection in Section 4E".
Rear Wheel Speed Sensor Removal and
Installation
Refer to "Rear Wheel Speed Sensor Removal and
Installation (4WD Model) in Section 4E".

Rear Wheel Speed Sensor Inspection

Refer to "Front and Rear Wheel Speed Sensor
Inspection in Section 4E".
Front Wheel Speed Sensor Encoder On-Vehicle
Inspection
Refer to "Front and Rear Wheel Speed Sensor On-
Vehicle Inspection in Section 4E".
Front Wheel Speed Sensor Encoder Removal
and Installation
Refer to "Front Wheel Speed Sensor Encoder Removal
and Installation in Section 4E".
Rear Wheel Speed Sensor Encoder On-Vehicle
Inspection
Refer to "Rear Wheel Speed Sensor Encoder On-
Vehicle Inspection in Section 4E".
Rear Wheel Speed Sensor Encoder Removal
and Installation
Refer to "Rear Wheel Speed Sensor Encoder Removal
and Installation in Section 4E".
Master Cylinder Pressure Sensor On-Vehicle
Inspection
S7RW0A4606006
1) Check that basic brake system other than ESP®
refer to "Brakes Diagnosis Note in Section 4A".
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) with ignition switch OFF.
Special tool
S7RW0A4606007
(A): SUZUKI scan tool
S7RW0A4606008
S7RW0A4606025
3) Turn ignition switch to ON position and select menu
"DATA LIST" mode of SUZUKI scan tool. Refer to
S7RW0A4606009
scan tool operator's manual for further derails.
4) When brake pedal is released, check "Master Cyl
Press" under "DATA LIST" of SUZUKI scan tool.
If pressure is out of specification, replace ESP®
hydraulic unit / control module assembly.
S7RW0A4606026
Master cylinder pressure specification
Brake pedal released: 0 ± 0.8 MPa (0 ± 8 kg/cm
± 113 psi)
5) Hoist vehicle and remove right-side front wheel.
S7RW0A4606010
6) Connect special tool with rubber hose (1) to Front
brake caliper bleeder plug (2).
Special tool
(A): 09956–02311
S7RW0A4606011
S7RW0A4606012
S7RW0A4606013
Electronic Stability Program:
1
2
1
4F-53
S7RW0A4606014
(A)
I5RW0A320008-01
, 0
2
(A)
I6JB01460025-01