Suzuki SX4 Service Manual page 853

39) After applying A/T fluid to intermediate shaft thrust
bearing rear race (3), thrust bearing (2) and front
race (1), install them to forward and reverse clutch
assembly (4).
Bearing race dimension
Front race
Outside
30.6 mm (1.20 in.) 28.2 mm (1.11 in.)
diameter
Thickness 2.0 mm (0.08 in.)
40) Apply A/T fluid to forward and reverse clutch
assembly (1).
Install forward and reverse clutch assembly while
rotating clockwise and counterclockwise frequently
to fit clutch discs to mating hubs.
NOTE
Before installation, align teeth of forward and
reverse clutch discs to facilitate installation.
41) Check for correct installation of forward and reverse
Rear race
2.0 mm (0.08 in.)
I2RH0B510294-01
42) After applying A/T fluid to O/D and 2nd coast brake
I2RH0B510295-01
Automatic Transmission/Transaxle:
clutch assembly as follows.
Measure distance "a" by using micrometer caliper (1)
and straightedge (2). If out of specification, remove
forward and reverse clutch assembly, forward clutch
hub, rear planetary sun gear subassembly and one-
way clutch No.1 assembly, and reinstall them
properly.
Distance between forward and reverse clutch
assembly and mating surface of transaxle case
"a": 27.1 – 29.4 mm (1.067 – 1.157 in.)
"a"
1
"a"
retaining plate (4), separator plate (3), discs (2) and
rear plate (1), install them to transaxle case (5).
5A-153
2
I2RH0B510296-01
I2RH0B510297-01