Suzuki SX4 Service Manual page 454

2C-3 Rear Suspension:
Installation
1) Install absorber upper bushes (1).
NOTE
For proper installing direction of absorber
upper bushes (1), refer to the figure.
2
2. Body panel
2) Install shock absorber (1), upper washers (2).
Tighten new rear shock absorber upper nut (4) and
lower nut (5) temporarily at this step.
CAUTION
!
Use new rear shock absorber upper nut.
Otherwise, nut may loosen.
1
5
3. Body panel
1
I5RW0A230028-01
4
2
3
I7RW01230017-01
3) Remove floor jack from rear axle.
4) Install rear wheel and tighten wheel nuts to specified
torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
5) Lower hoist and bounce vehicle up and down
several times to stabilize suspension.
6) Tighten nuts to specified torque.
Tightening torque
Rear shock absorber upper nut (a): 30 N·m (3.0
kgf-m, 22.0 lb-ft)
Rear shock absorber lower nut (b): 90 N·m (9.0
kgf-m, 65.0 lb-ft)
7) For hatchback model, install access hole cover in
quarter inner trim.
8) For sedan model, install quarter inner trim.
(a)
(b)
I5RW0A230006-01