Suzuki SX4 Service Manual page 35

Accessory Drive Belt Replacement
Water Pump and Generator Drive Belt
Replace belt with new one referring to "Water Pump /
Generator Drive Belt Removal and Installation in Section
1J".
A/C Compressor Drive Belt (If Equipped)
Replace belt with new one referring to "Compressor
Drive Belt Removal and Installation: Manual Type in
Section 7B" or "Compressor Drive Belt Removal and
Installation: Automatic Type in Section 7B".
Valve Lash (Clearance) Inspection
Inspect intake and exhaust valve lash and adjust as
necessary.
Refer to "Valve Lash (Clearance) Inspection in Section
1D" for valve lash inspection and adjustment procedure.
1. Camshaft
Engine Oil and Filter Change
WARNING
!
• New and used engine oil can be
hazardous.
Be sure to read "WARNING" in "General
Precautions in Section 00" and observe
what is written there.
• Step 1) – 7) outlined below must be
performed with ENGINE NOT RUNNING.
For Step 8), be sure to have adequate
ventilation while engine is running.
S7RW0A0206002
S7RW0A0206003
I2RH0B020003-02
2. Thickness gauge
S7RW0A0206004
Maintenance and Lubrication:
Before draining engine oil, check engine for oil leakage.
If any evidence of leakage is found, make sure to correct
defective part before proceeding to the following work.
1) Drain engine oil by removing drain plug.
2) After draining oil, wipe drain plug clean. Reinstall
drain plug.
Tightening torque
Engine oil drain plug (a): 35 N·m (3.5 kgf-m, 25.5
lb-ft)
3) Loosen oil filter by using oil filter wrench (special
tool).
Special tool
(A): 09915–47331
NOTE
Before fitting new oil filter, be sure to oil its
O-ring. Use engine oil for this purpose.
0B-4
I2RH0B020004-01
I2RH0B020005-01
IYSQ01020009-01