Suzuki SX4 Service Manual page 141

Step
5 Wire harness check
1) Measure voltage between "GRN" wire terminal of electric
throttle body assembly connector and engine ground
with ignition switch turned ON.
Is voltage 4 – 6 V?
6 Wire harness check
1) Turn OFF ignition switch.
2) Remove ECM from its bracket with ECM connectors
connected.
3) Check for proper connection of ECM connector at "C01-
43" and "C01-54" terminals.
4) If OK, measure voltage between "C01-54" terminal of
ECM connector and engine ground with ignition switch
turned ON.
Is voltage 4 – 6 V?
7 Wire harness check
1) Disconnect connectors from ECM with ignition switch
turned OFF.
2) Measure resistance between "GRN" and "RED" wire
terminals of electric throttle body assembly connector.
Is resistance infinity?
8 Wire harness check
1) Turn ON ignition switch.
2) Measure voltage between "C01-54" terminal of ECM
connector and engine ground.
Is voltage 0 V?
9 Ground circuit check
1) Turn OFF ignition switch.
2) Measure resistance between "BLK" wire terminal of
electric throttle body assembly connector and engine
ground.
Is resistance below 5
10 Ground circuit check
1) Remove ECM from its bracket with ECM connectors
connected.
2) Check for proper connection of ECM connector at "C01-
42" terminal.
3) Measure resistance between "C01-42" terminal of ECM
connector and engine ground with ignition switch turned
OFF.
Is resistance below 5
11 Electric throttle body assembly check
1) Check throttle pedal position sensor referring to "Throttle
Position Sensor Performance Check" under "Electric
Throttle Body Assembly On-Vehicle Inspection in
Section 1C".
Is output voltage within specified value?
Action
Ω
?
Ω
?
Engine General Information and Diagnosis:
Yes
Go to Step 9.
"GRN" wire is open or
high resistance circuit.
Go to Step 8.
Substitute a known-
good ECM and recheck.
Go to Step 11.
"BLK" wire is open or
high resistance circuit.
Substitute a known-
good ECM and recheck.
1A-91
No
Go to Step 6.
Go to Step 7.
"GRN" wire is shorted to
"RED" wire.
"GRN" wire is shorted to
power circuit.
Go to Step 10.
Faulty ECM ground
circuit. If circuit is OK,
substitute a known-
good ECM and recheck.
Replace electric throttle
body assembly.