Suzuki SX4 Service Manual page 147

Step
1 Was "Engine and Emission Control System Check"
performed?
2 HO2S-1 output voltage check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Warm up engine to normal operating temperature and
keep it at 2000 r/min. for 60 sec.
3) Repeat racing engine (Repeat depressing accelerator
pedal 5 to 6 times continuously to enrich A/F mixture and
take foot off from pedal to enlean it) and check HO2S
output voltages displayed on scan tool.
Is over 0.6 V and below 0.3 V indicated?
3 HO2S-1 ground check
1) Disconnect connector from HO2S-1 with ignition switch
turned OFF.
2) Check for proper connection to HO2S-1 at "BLK/RED",
"WHT", "BLK/WHT" and "ORN" wire terminals.
3) If wire and connection are OK, measure resistance
between "ORN" wire terminal of HO2S-1 connector and
engine ground.
Is resistance less than 5
4 Wire circuit check
1) Turn OFF ignition switch.
2) Remove ECM from its bracket with ECM connectors
connected.
3) Measure resistance between "WHT" wire terminal of
HO2S-1 connector and "C01-10" terminal of ECM
connector.
Is resistance less than 5
5 Wire circuit check
1) Disconnect connectors from ECM with ignition switch
turned OFF.
2) Measure resistance between "WHT" wire terminal of
HO2S-1 connector and vehicle body ground.
Is resistance infinity?
6 HO2S-1 heater circuit check
1) Check HO2S-1 heater circuit referring to "DTC P0031 /
P0032: HO2S Heater Control Circuit Low / High
(Sensor-1)".
Is it in good condition?
7 Exhaust system check
1) Check exhaust system for exhaust gas leakage.
Is it OK?
Action
Ω
?
Ω
?
Engine General Information and Diagnosis:
Yes
Go to Step 2.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00". If check result is
OK, go to Step 3.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Go to Step 7.
Go to Step 4 in "DTC
P0171 / P0172: Fuel
System Too Lean /
Rich".
If it is in good condition,
go to Step 8.
1A-97
No
Go to "Engine and
Emission Control
System Check".
Go to Step 3.
"ORN" wire is open or
high resistance circuit.
Poor "C01-57" terminal
connection. Faulty ECM
ground.
If they are OK,
substitute a known-
good ECM and recheck.
"WHT" wire is high
resistance circuit or
open circuit. Poor "C01-
10" terminal connection
of ECM connector.
Faulty ECM ground. If
they are OK, substitute
a known-good ECM and
recheck.
"WHT" wire is shorted to
ground circuit.
Repair HO2S-1 circuit.
Repair leakage of
exhaust system.