Wireless Modem; Form A Network; Radio Synch - Honeywell FMC2000 User Manual

Table of Contents

To exit: Press Back to return to the Communications menu, or

press Exit to return to the monitoring screen without saving your

changes.

18.1 Wireless Modem

To enter Wireless Modem settings:

1. Input the 6-digit advanced password.

2. Press Enter. The menu appears.

3. Step through the menu choices by using the up and down

arrows.

4. Select a menu choice by pressing Enter. Otherwise, press Back

to return to the Wireless Modem menu without making

changes, or press Exit to return to the monitoring screen.

The FMC2000 automatically forms a network under a single PAN

ID. The controller radio picks up the cleanest channel by scanning

radio channels. To ensure the best communication signal strength,

use this procedure when you set up a network for the first time, or

if you reconfigure the network.

1. Press Enter. A box appears with the message "Confirm?"

2. Press Enter to make and save a selection. Otherwise, press

Back to return to the Wireless Modem menu without saving

your changes, or press Exit to return to the monitoring screen

without saving your changes.

The FMC2000 sends a radio synchronization command to bind the

detectors to the controller within the same network.

When this is on, the monitors in a network synchronize with the

FMC2000. Therefore, when a message is sent by a monitor to the

FMC2000 User's Guide

Table of Contents