Num; Slave Id - Honeywell FMC2000 User Manual

16.7 Num

Total number included in the logic group. This tells the number of
monitors included in the logic group. If "ALL" has been selected,
the number representing all of the monitors is shown, rather than
an indication of "ALL."
To add a monitor's number (or all):
1. Press Enter. A menu of selectable remote monitors (their Unit
ID is shown) or "ALL" is shown.
2. Press Enter to scroll down.
3. Press the down arrow to highlight a monitor or ALL.
4. Press Enter to add the monitor or ALL to the list in the right
column.
To remove a monitor's number (or ALL) from the selected
list:
1. Press Enter. The cursor is on the "T:" (total) header.
2. Press the down arrow. The cursor highlights the top of the
second list ("S:").
3. Press Enter to scroll down the list.
4. Make your selection and press Enter to remove it from the
column.

16.8 Slave ID

This is the monitor's ID. This gives the Monitor ID(s) for each
Voting grouping for each of the relays.
1. Press Enter to highlight the relay.
2. Scroll down using the down-arrow key.
3. Press Enter, and a new column appears.
4. Use up and down arrows to select monitors to be included.
5. Press Enter.
6. Press Exit or Back to leave this menu.
FMC2000 User's Guide
57