Table of Contents
Advertisement
To place the FMC2000 in Standby Mode and replace the SD
card:
1. Hold down the "2" key until you see the display message
"Standby..." The screen goes blank.
2. Release the "2" key.
3. Unlock and open the front panel.
4. Check that LED next to the SD card is not blinking.
5. Remove SD Card by pressing in (lightly), and allowing it to
release.
6. Replace the SD card.
To exit Standby Mode and restart datalogging:
1. Hold down the "2" key. The screen illuminates and gives the
message "Working..."
2. Release the "2" key.
When the reading display is shown, datalogging is on again, and
the FMC2000 is fully operational.
Inserting an SD card. Press the SD card into the slot with the
angled notch on the right. Press until it locks into place, making a
"click" sound.
FMC2000 User's Guide
20
Advertisement
Table of Contents
