Log Interval; Log Method - Honeywell FMC2000 User Manual

17.2 Log Interval

To change the Datalog Inverval:
1. Press Enter. A box appears, saying "Interval(60~600):"
This prompts you to input the number of seconds from one
datalog point to the next.
2. Set a value by using the number keys on the keypad.
3. Press Enter to make and save a selection. Otherwise, press
Back to return to the Datalog menu without saving your
changes, or press Exit to return to the monitoring screen
without saving your changes.

17.3 Log Method

The FMC2000 can save log data either at the log interval you set
or only when an alarm event takes place. If you select "Alarm,"
then a log is only stored when there is an alarm event. This can
save a great deal of space on the SD card used to store the data.
However, it does not store any other data at any other time.
To change the logging method:
1. Press Enter. The checkbox and accompanying text in the right
column is labeled either "Alarm" or "Interval."
2. Change the logging type by pressing Enter until you see the
type of logging you want.
3. When you are done, press Back to return to the Datalog menu,
or press Exit to return to the monitoring screen.
FMC2000 User's Guide
59