Instrument Location; Serial Number; Firmware Version; Build Date - Honeywell FMC2000 User Manual

13.8 Instrument Location

This tells the location of the FMC2000 controller. You can set this
information in the FMC2000 and it is included in the datalog
information on the SD card.
1. Press Enter to change the instrument's location.
Note: Press Lock/Cancel to change from upper-case to lower-
case letters or to select numerals.
2. Press each letter to be input.
3. When you are done setting the location, press Enter. This exits
the Instrument Location setting menu.

13.9 Serial Number

This is the FMC2000's serial number. This is a read-only
parameter, and it cannot be changed.

13.10 Firmware Version

This is the current firmware version operating the FMC2000. This
is a read-only parameter, and it cannot be changed.

13.11 Build Date

This is the current firmware's build (creation) date. This is a read-
only parameter, and it cannot be changed.

13.12 Build Time

This is the current firmware's build (creation) time that
accompanies the build date. This is a read-only parameter, and it
cannot be changed.
FMC2000 User's Guide
44