Wireless Communication Indicator; Deploying The Echoview - Honeywell EchoView User Manual

5.6. Wireless Communication Indicator

The display employs an antenna icon to show that the radio is on. A letter "H" indicates that the
EchoView is operating in the Host mode. It is located in the upper right corner of the display:
Signal strength is represented by vertical bars to the right of the antenna icon. The greater the
number of bars to the right of the antenna icon, the better the connection quality.
Note: An "X" indicates no signal is detected.

6. Deploying The EchoView

When deploying a MeshGuard network that utilizes EchoViews, make sure the rest of the network has
been set up before using an EchoView. The EchoView gets its information about the monitors on a
network from the FMC2000 controller. It does not aggregate network data from all its nodes. Therefore,
make sure the FMC2000 is operational and in communication with all monitors on the network, as well as
with the EchoView.
Before deploying an EchoView, it is important to have the Pan ID and Channel number on which the rest
of the network is operating. Without these numbers to program into your EchoView, you cannot make it
communicate with the network.
EchoView User's Guide
16
Radio on
Indicator