Clear Ip Ospf - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
md5 KEY
Default
No area ID is predefined.
No router ID is predefined.
The default authentication type is NULL.
No authentication-key is predefined.
No message-digest-key is predefined.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If a non-zero area is not physically connected to the zero area, it must be connected to the zero area via
a virtual link. The virtual link is a point-to-point link. The router will send the OSPF message to the
neighbor router as unicast IP packet.
Example
This example shows how to establish a virtual link with a hello-interval and dead-interval of 5 and 10
seconds respectively.
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# area 1 virtual-link 10.10.11.50 dead-interval 10 hello-interval
5
Switch(config-router)#
This example shows how to configure the parameters for a virtual link at area 1 and remote ID of
192.168.255.1. The key is defined is a simple password authentication, defined as "yourpass" and the
authentication type is set to simple password.
Switch# configure terminal
Switch(config)# router ospf 1
Switch(config-router)# area 1 virtual-link 192.168.255.1 authentication
Switch(config-router)# area 1 virtual-link 192.168.255.1 authentication-key yourpass
Switch(config-router)#

71-6 clear ip ospf

This command is used to restart the IPv4 OSPF process.
clear ip ospf process [vrf VRF-NAME]
Parameters
vrf VRF-NAME
Default
digest authentication.
(Optional) Specifies the IPv4 OSPF VRF process.
808