Mpls Label - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# interface ethernet1/2/1
Switch(config-if)# service encapsulation svid 10
Switch(config-if-srv)# xconnect 130.1.1.2 2 encapsulation mpls
Switch(config-if-xconn)# backup peer 120.1.1.2 3
Switch(config-if-xconn)#
This example shows how to configure the switch to back up to the primary PW 10 seconds after the
primary PW comes back online.
Switch# configure terminal
Switch(config)# interface ethernet1/0/2
Switch(config-if)# service encapsulation svid 10
Switch(config-if-srv)# xconnect 130.1.1.2 2 encapsulation mpls
Switch(config-if-xconn)# backup peer 120.1.1.2 3 delay 10
Switch(config-if-xconn)#
112-2

mpls label

This command is used to assign the local label and the remote label used by the manual PW.
mpls label LOCAL-LABEL REMOTE-LABEL
no mpls label
Parameters
LOCAL-LABEL
REMOTE-LABEL
Default
None.
Command Mode
Xconnect Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available when the manual option is specified in the xconnect command. That is,
the local label and remote label are manual assigned. If the manual option is not specified, the local and
remote labels are assigned and exchanged by the LDP protocol. The service will only be started after the
label is assigned.
Example
This example shows how to assign the local label and the remote label for a manual PW.
Switch# configure terminal
Switch(config)# interface ethernet1/0/2
Switch(config-if)# service encapsulation svid 10
Switch(config-if-srv)# xconnect 130.1.1.2 2 encapsulation mpls manual
Specifies the incoming label by which the packets of the PW are
identified.
Specifies the output label used to encapsulate the packet transmitted
to the PW.
1247