Show Mpls Ldp Neighbor - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Oper State
Targeted Hello Accept : Acceptable
Hello Interval
Hello Hold Time
Distribution Method
Interface: if2
--------------------------------------
Admin State
Oper State
Targeted Hello Accept : Acceptable
Hello Interval
Hello Hold Time
Distribution Method
Total Entries: 2
Switch#
67-36

show mpls ldp neighbor

This command is used to display LDP peer information.
show mpls ldp neighbor [IP-ADDRESS]
Parameters
IP-ADDRESS
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display all peers learned by LDP.
Example
This example shows how to display all LDP neighbors.
Switch# show mpls ldp neighbor
Peer : 202.11.1.1:0
--------------------------------------
Protocol Version
Transport address
Keep Alive Time
: Disabled
: 5(Sec)
: 15(Sec)
: DoD
: Enabled
: Disabled
: 5(Sec)
: 15(Sec)
: DoD
Specifies the IP address used as the peer LSR ID. If not specified, all
neighbors will be displayed.
: 1.0
: 202.11.1.1
: 40 (sec)
773