Ipv6 Ospf Area - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-rtr)# redistribute rip
Switch(config-rtr)#
72-8 distance ospf
This command is used to configure the distance for specific OSPF routes. Use the no form of the
command to restore to the default setting.
distance ospf {external | inter-area | intra-area} DISTANCE
no distance ospf
Parameters
external
inter-area
intra-area
DISTANCE
Default
By default, the distance value is 110 for all OSPF routes.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the distance ospf command to set the administrative distance for specific OSPF routes. The
distance ospf command acts as the distance command which determines which routes will be installed
in routing table.
Numerically, an administrative distance is an integer from 0 to 255. In general, the higher the value is, the
lower the rating of trustworthiness is. The administrative distance of 255, means that the routing
information source cannot be trusted and should be ignored.
Example
This example shows how to configure the distance of external routes to 50.
Switch# configure terminal
Switch(config)# ipv6 router ospf 1
Switch(config-rtr)# distance ospf external 50
Switch(config-rtr)#

72-9 ipv6 ospf area

This command is used to configure an area of an OSPF process on an interface. To disable OSPF
routing for the interfaces defined, use the no form of this command.
Specifies the distance for OSPF external routes.
Specifies the distance for OSPF inter-area routes.
Specifies the distance for OSPF intra-area routes.
Specifies the distance value of specific OSPF routes in the range 1 to
254.
861