Show Ip Igmp Snooping - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
2
3
Default
By default, there is no limit on the minimum version.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. This setting only applies to the filtering
of IGMP membership reports.
Example
This example shows how to restrict all IGMPv1 hosts to join.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping minimum-version 2
Switch(config-vlan)#
This example shows how to restrict all IGMPv1 and IGMPv2 hosts disallowed to join.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping minimum version 3
Switch(config-vlan)#
This examples shows how to remove the restriction configured on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# no ip igmp snooping minimum-version
Switch(config-vlan)#
44-20

show ip igmp snooping

This command is used to display IGMP snooping information on the switch.
show ip igmp snooping [vlan VLAN-ID]
Parameters
VLAN-ID
Default
None.
Command Mode
Specifies to filter out IGMPv1 messages.
Specifies to filter out IGMPv1 and IGMPv2 messages.
Specifies the VLAN to be displayed.
547