Multiprotocol Label Switching (Mpls) Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
67. Multiprotocol Label Switching (MPLS)
Commands
67-1 backoff
This command is used to configure the initial and maximum back-off delay time. Use the no form of this
command to restore the default value.
backoff INIT-TIME MAX-TIME
no backoff
Parameters
INIT-TIME
MAX-TIME
Default
Initial time: 15 seconds.
Maximum time: 600 seconds.
Command Mode
LDP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The LDP back-off delay time is a mechanism to prevent an endless sequence of session setup failures
that occur between two LSRs with incompatible settings.
Example
This example shows how to configure the initial and maximum back-off delay time to 100 and 200
seconds.
Switch# configure terminal
Switch(config)# mpls ldp configuration
Switch(config-ldp)# backoff 100 200
Switch(config-ldp)#
67-2 class map cos-exp
This command is used to configure the Class of Service (CoS) to the Experimental bits (EXP) mapping of
the policy. Use the no command to remove the setting.
class map cos-exp COS-LIST to EXP-VALUE
no class map cos-exp [COS-LIST]
Specifies the initial back-off delay time. The range is from 15 to 65535
seconds.
Specifies the maximum back-off delay time. The range is from 120 to
65535 seconds.
745