Table of Contents
Advertisement
4 Web-based Switch Configuration
This switch provides a configurable MDI/MDIX function for users. The switches can be set as an MDI port in
order to connect to other hubs or switches without an Ethernet crossover cable.
Auto MDI/MDIX is designed on the switch to detect if the connection is backwards, and automatically
chooses MDI or MDIX to properly match the connection. The default setting is "Auto" MDI/MDIX.
Flow Control: You can enable this function to mitigate the traffic congestion. Ports configured for full-duplex
use 802.3x flow control, half-duplex ports use backpressure flow control. The default setting is Disabled.
Auto Downgrade: Enable or disable automatically downgrading advertised speed. This function only takes
effect, when Speed is configured as Auto.
Capability Advertised: When the Speed is set to Auto, these capabilities are advertised during auto-
negotitation.
System > Port Description
Port description can be given on this page.
From Port / To Port: Specifies the range of ports to describe.
Description: Specifies the description for the chosen ports.
Click Apply to set the description in the table.
System > Port Configuration > Port Error Disabled
The Port Error Disabled page displays the information about ports that have had their connection status
disabled, for reasons such as STP loopback detection or link down status.
Port: Displays the port that has been error disabled.
Port State: Describes the current running state of the port, whether Enabled or Disabled.
Connection Status: This field will read the uplink status of the individual ports, whether Enabled or Disabled.
Reason: Describes the reason why the port has been error-disabled, such as a STP loopback occurrence.
System > IP Interface
Used to configure IP Interface parameters for system interface.
Figure 4.19 – System > Port Description
Figure 4.20 – System > Port Configuration > Port Error Disabled
D-Link DGS-2000 Series Ethernet Switch User Manual
3
3
2
2
Advertisement
Table of Contents
