Show Ip Ospf - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# router ospf 1
Switch(config-router)# router-id 10.10.10.60
Switch(config-router)#
71-25

show ip ospf

This command is used to display general information about the OSPF routing process.
show ip ospf [vrf VRF-NAME]
Parameters
vrf VRF-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display general OSPF protocol information. It provides system wide statistics and
per-area statistics for OSPF. The LSDB database overflow limit is the capacity for the LSA table size.
Example
This example shows how to display general OSPF protocol information.
Switch#show ip ospf
Operational Router ID 222.200.23.1
Process uptime is 0DT0H18M54S
Conforms to RFC2328, and RFC1583 Compatibility flag is disabled
This router is an ABR, ABR Type is Standard (RFC2328)
This router is an ASBR (injecting external routing information)
SPF schedule Hold time between two SPFs 3 secs
Number of external LSA 2010. Checksum 0x3ef91d0
Number of LSA originated 261
Number of LSA received 2131
Number of current LSA 2184
LSDB database overflow limit is 49152
Number of areas attached to this router : 5
Area 0.0.0.0 (BACKBONE)
Number of interface in this area is 15 active interface number is 15
Number of fully adjacent neighbors in this area is 15
SPF algorithm executed 19 times
Number of LSA 37
Area 0.0.0.1
Number of interface in this area is 1 active interface number is 1
Number of fully adjacent neighbors in this area is 1
(Optional) Specifies the IPv4 OSPF VRF process.
823