Multicast Listener Discovery (Mld) Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
64. Multicast Listener Discovery (MLD)
Commands
64-1 ipv6 mld enable
This command is used to enable the MLD protocol state. Use the no form of this command to disable the
MLD protocol state.
ipv6 mld enable
no ipv6 mld enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. This command only takes effect when
the interface has an IPv6 address configured.
Example
This example shows how to enable MLD on VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 mld enable
Switch(config-if)#
64-2 ipv6 mld last-listener-query-count
This command is used to configure the number of group-specific or group-source specific queries sent
before the router assumes there are no local members of a group. Use the no form of the command to
revert to the default setting.
ipv6 mld last-listener-query-count VALUE
no ipv6 mld last-listener-query-count
Parameters
VALUE Specifies the last member query count. The valid range is 1 to 7.
714