Show Ip Igmp Snooping Groups - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display IGMP snooping information for all VLANs where IGMP snooping is enabled.
Example
This example shows how to display IGMP snooping configurations.
Switch# show ip igmp snooping
IGMP snooping global state
Dynamic mrouter aging time
VLAN #1 Configuration
IGMP snooping state
Minimum version
Fast leave
Report suppression
Suppression time
Querier state
Query version
Query interval
Max response time
Robustness value
Last member query interval
Proxy reporting
Rate limit
Ignore topology change
Total Entries: 1
Switch#
44-21

show ip igmp snooping groups

This command is used to display IGMP snooping group information learned on the switch.
show ip igmp snooping groups [vlan VLAN-ID [,|-] | [IP-ADDRESS]
Parameters
vlan VLAN-ID [,|-]
IP-ADDRESS
Default
None.
: Enabled
: 300 seconds
: Enabled
: v1
: Disabled (host-based)
: Disabled
: 10 seconds
: Disabled
: v3
: 125 seconds
: 10 seconds
: 2
: 1 seconds
: Enabled (Source 1.2.3.4)
: 0
: Disabled
(Optional) Specifies the VLAN interface to be displayed. If no VLAN is
specified, IGMP snooping group information of all VLANs will be
displayed, at which IGMP Snooping is enabled.
(Optional) Specifies the group IP address to be displayed. If no IP
address is specified, all IGMP group information will be displayed.
548