Show Lldp Local Interface - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
LLDP-MED Organizationally Specific TLVs:
LLDP-MED Capabilities TLV
LLDP-MED Network Policy TLV
LLDP-MED Extended Power Via MDI PSE TLV
LLDP-MED Inventory TLV
LLDP-DCBX Organizationally Specific TLVs:
LLDP-DCBX ETS Configuration TLV
LLDP-DCBX ETS Recommendation TLV
LLDP-DCBX Priority-based Flow Control Configuration TLV :Disabled
Switch#
Display Parameters
Enabled Management
Address
Enabled Port and Protocol
VLAN ID
Enabled VLAN Name
Enabled Protocol Identity
58-23

show lldp local interface

This command is used to display physical interface information that will be carried in the LLDP TLVs and
sent to neighbor devices.
show lldp local interface INTERFACE-ID [, | -] [brief | detail]
Parameters
INTERFACE-ID
,
-
brief
detail
Displays the enabled IPv4/IPv6 addresses. The indicated string
"(None)" means that the user did not configure the management
address with the lldp management-address command or the enabled
default IPv4 and IPv6 addresses are not applicable.
This indicating string is shown when there are enabled port and
protocol VLANs. The VLAN list is the configured enabled VLANs. If
there is no configured PPVID VLAN, the string is "(None)".
This indicating string is shown when there are enabled VLANs for
sending VLAN Name TLVs. The VLAN list includes the configured
enabled VLANs. If there is no configured VLAN for the VLAN Name
TLV, the string is "(None)".
Displays the enabled protocol string for protocol identity TLVs. If there
is no enabled protocol for protocol identity TLVs, the string is "(None)".
Specifies the interface's ID. Valid interfaces are physical interfaces.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
(Optional) Specifies to display the information in brief mode.
(Optional) Specifies to display the information in detailed mode. If
neither brief nor detail is specified, display the information in the
663
:Enabled
:Disabled
:Disabled
:Disabled
:Disabled
:Disabled