Show Vrrp - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to enable VRRP authentication on an interface. The authentication is applied to all
virtual routers on this interface. The devices in the same VRRP group must have the same authentication
password.
Example
This example shows how to configure one interface's VRRP authentication:
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# vrrp authentication test
Switch(config-if)#
113-8

show vrrp

This command is used to display the VRRP status.
show vrrp [interface INTERFACE-ID [VRID]]
Parameters
INTERFACE-ID
VRID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the VRRP related setting and status.
Example
This example shows how to display the VRRP status for all interfaces.
Switch# show vrrp
vlan1 – VRID 7
State is Master
Virtual IP address is 20.1.1.1
Virtual MAC address is 00-00-5e-00-01-07
Advertisement interval is 1 seconds
Preemption is enabled
Priority is 255
No critical IP address
Master router is 20.0.1.1 (local)
vlan1 – VRID 8
State is Master
(Optional) Specifies the interface ID.
(Optional) Specifies the virtual router identifier that identifies the VRRP
group. The valid range is from 1 to 255.
1259