Vrrp Priority - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The maser will constantly send VRRP advertisements to communicate the related information of the
current master virtual router. This command configures the interval between advertisement packets and
the time before other routers declare the master router as down. All routers in a VRRP group must use
the same timer values.
Example
This example shows how to configure the router to send advertisements for VRRP 7 every 10 seconds on
interface VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# vrrp 7 timers advertise 10
Switch(config-if)#
113-4

vrrp priority

This command is used to configure the priority of a virtual router. To restore the default priority, use the
no form of this command.
vrrp VRID priority PRIORITY
no vrrp VRID priority
Parameters
VRID
PRIORITY
Default
By default, this value is 100.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The master of a virtual router is elected based on the priority setting. The router that owns the virtual
router IP address has the highest priority to be elected.
The router with the highest priority will become the master, and other routers with a lower priority will then
act as the backup for the virtual router. Each router should be configured with different priority values. If
there are multiple routers with the same highest priority value, the router with the highest numbers in its
IP address will become the master.
The router that is the IP address owner of the VRRP group is always the master of the VRRP group.
Specifies the virtual router identifier that identifies the VRRP group.
The valid range is from 1 to 255.
Specifies the priority of the virtual router. A higher value means a
higher priority. The valid range is from 1 to 254.
1256