Remote Login Module - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

remote login module

To remotely connect to a specific module, use the remote login module configuration command.
Syntax Description
mod
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(19)EW
Usage Guidelines This command applies only to the Access Gateway Module on Catalyst 4500 series switches.
The valid values for mod depends on the chassis used. For example, if you have a Catalyst 4506 chassis,
valid values for the module are from 2 to 6. If you have a 4507R chassis, valid values are from 3 to 7.
When you execute the remote login module mod command, the prompt changes to Gateway#
The remote login module command is identical to the session module mod and the attach module mod
commands.
Examples This example shows how to remotely log in to the Access Gateway Module:
Switch# remote login module 5
Attaching console to module 5
Type 'exit' at the remote prompt to end the session
Gateway>
Related Commands Command
attach module
session module
OL-27596 -01
remote login module mod
Target module for the command.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Description
Remotely connects to a specific module.
Logs in to the standby supervisor engine using a virtual console.
remote login module
2-589