Hw-Module Power - Cisco Catalyst 4500 Series Command Reference Manual

hw-module power

hw-module power
To turn the power off on a slot or line module, use the no hw-module power command. To turn the power
back on, use the hw-module power command.
Syntax Description
slot
module
number
Defaults After a boot up, the power is on.
Command Modes
Global configuration mode
Command History Release
12.1(8a)EW
12.2(18)EW
Usage Guidelines
After you enter no hw-mod mod x power command and OIR the linecard, the configuratio persists and
is valid for any slot in the chassis it is applied to.
Examples
This example shows how to shut off power to a module in slot 5:
Switch(config)# no hw-module slot 5 power
Related Commands Command
clear hw-module slot password
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-274
hw-module [slot | module] number power
no hw-module [slot | module] number power
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Add slot and module keywords.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
(Optional) Specifies a slot on a chassis.
(Optional) Specifies a line module.
Slot or module number.
Description
Clears the password on an intelligent line module.
OL-27596 -01