Power Dc Input - Cisco Catalyst 4500 Series Command Reference Manual

power dc input

power dc input
To configure the power DC input parameters on the switch, use the power dc input command. To return
to the default power settings, use the no form of this command.
Syntax Description
watts
Defaults
DC power input is 2500 W.
Command Modes Global configuration mode
Command History Release
12.1(11)EW
12.1(13)EW
Usage Guidelines If your interface is not capable of supporting Power over Ethernet, you will receive this message:
Power over Ethernet not supported on interface Admin
Examples This example shows how to set the total capacity of the external DC power source to 5000 W:
Switch(config)# power dc input 5000
Switch(config)#
Related Commands Command
show power
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-532
power dc input watts
no power dc input
Sets the total capacity of the external DC source in watts; valid values are from
300 to 8500.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for dc input was added.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Displays information about the power status.
OL-27596 -01