Monitor Capture [Interface | Vlan | Control-Plane] - Cisco Catalyst 4500 Series Command Reference Manual

monitor capture [interface | vlan | control-plane]

monitor capture [interface | vlan | control-plane]
To specify one or more attachment points with direction, use the monitor capture [interface | vlan |
control-plane] command. To remove the attachment point, use the no form of this command.
Syntax Description
name
interface name
vlan num
control-plane
input | output | both
Defaults
None
Command Modes Privileged EXEC mode
Command History Release
IOS XE 3.3.0SG/
15.1(1)SG
Usage Guidelines
Specifies one or more attachment points with direction. We can specify a range of interfaces also. The
command can be repeated as many times as needed to add multiple attachment points.
We need to mention at least one attachment point. For VLAN, the direction has to be set to both.
Examples The following example shows how to add an attachment point:
Switch# monitor capture mycap interface gigabitEthernet 3/1 in
The following example shows how to remove an attachment point:
Switch# no monitor capture mycap interface gigabitEthernet 3/1 in
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-468
monitor capture name [{interface name | vlan num | control-plane} {in | out | both}]
no monitor capture name [{interface name | vlan num | control-plane} {in | out | both}]
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Specifies a capture point.
Specifies an interface. Interface range is allowed.
Specifies a VLAN.
Specifies control plane.
Specific traffic direction.
OL-27596 -01